PRODUCT
Precautions for welding of iron castings
Time:2021-11-25 10:15:52 Author:Daguang JinpengClick:126
Iron castings,as the name suggests,are objects cast with molten iron.Molten iron is mainly used for some ornaments,such as swords.Cast iron welding is to weld cast iron together to form a new component.Next,let's talk about cast iron welding methods and precautions.
Cast iron welding method:
Place the workpiece obliquely so that the weld is in upslope welding or semi vertical welding to reduce the fusion ratio.(do not forget to clean before welding).
Preheat around the groove at 200~250℃before welding to reduce the temperature difference between the weld and the workpiece.(thanks for paying attention to Dingding automatic welding)
The welding rod shall be cast 308 with diameter of d3.2mm and 4mm.Before welding,the electrode shall be baked at about 150℃for 2h.
D3.2mm electrode with current of 90~100A shall be selected for the first,second and third pass welding.D4mm electrode with current of 130~160A shall be selected for the last two layers of weld beads.DC positive connection is adopted.
Slag shall be removed after welding of each layer.
After welding,heat it to 300~350℃within 200mm around the welding area,keep it warm for 30min,and cover it with aestos powder to slow cooling.
Welding precautions:
In order to reduce the penetration on both sides of the groove,welding with appropriate speed without swinging can be adopted.The middle of the weld can swing slightly,but the swing range should be small.
When the repair welding workpiece is thick,the groove section is large,and multi-layer and multi pass welding is adopted.Zibo iron castings have large weld cross-section and strong shrinkage stress,which is easy to form weld stripping.Therefore,a reasonable welding sequence shall be adopted.
Short segment welding,intermittent welding,scattered welding and step-by-step back welding are adopted.Short section welding,i.e.each section is about 10~40mm long.Intermittent welding,that is,stay for a while after welding for a period of time,and then weld the next weld when the workpiece is cold to 50~60℃to prevent heat concentration.Dispersed welding:weld one section at one part and then weld at another part to reduce temperature difference and stress.Compared with continuous welding,the step-by-step back welding method can greatly reduce the peak tensile stress of the weld,so it is helpful to prevent the occurrence of weld cracks.
Hammer weld.When hammering the weld,the temperature shall be above 400℃.Hammer the weld with a small round head to extend the weld metal and relax the stress in the weld repair area.Do not hammer the welded layer and the subsequent layer.
next:Several factors affecting the quality of iron castings
